Posted by Monica Siri on September 30, 2009 at 4:44 PM
Hello everybody,
after my first posts I have noticed a loss of brightness between the prepared version (post processed with CS4) and the posted version.
Is there a trick or I'm wrong anything?
Thank you for your precious advices.
Monica, are you checking the image out with the use of the View>Proof Setup. Typically if your Workspace is set for say Adobe RGB 98 when you convert to sRGB for web viewing it is always good to view it under the View>Proof Setup>Custom>Device>sRGB. It should provide you with a finished look after you have completed web image preparation. If you see a really different look from your assigned Workspace and sRGB, then you will need to figure out what might be the issue from that point. It should not be a really noticeable change overall.
Posted by Monica Siri on October 1, 2009 at 3:47 AM
Paul, thanks a lot.
It's a good tip, I'll try next time.
Discussion
2 repliesafter my first posts I have noticed a loss of brightness between the prepared version (post processed with CS4) and the posted version.
Is there a trick or I'm wrong anything?
Thank you for your precious advices.
It's a good tip, I'll try next time.